WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES SECTION 7 All part numbers in BLUE are new for the OldBook. 293 See FATBOOK For Late Model Applications DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 5-7 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. PART # DESCRIPTION 0929-0043 For 84-99 Evolution Big Twin POWERGLIDE™ STEADY ROLL TAPPETS •The same Powerglide™ advantage (oil-fed axle, billet steel body, precision-fit hydraulics), but now incorporates a Steady Roll bronze bushing in place of the needle bearing roller •These tappets have undergone extensive development to increase load, lubrication, hydraulic and life capacities •Billet body •Increased roller width •Roller perpendicularity held to 0.0002” •Hand-honed hydraulic unit cavity •Dynamic load capacities increased over 30% •Lubrication capacities for hydraulic unit and valve train (top end) increased 10% •Lubrication capacities for the roller, cams and cam bearings have increased 100% for increased cooling •Sold each •Made in the U.S.A. PART # DESCRIPTION 0929-0019 For 48-57 Big Twin, repl. OEM #18492-48 TAPPET •Standard size •Sold each •Made in the U.S.A. PART # DESCRIPTION 0929-0018 For 84-99 Evolution Big Twin HP+® HYDRAULIC LIFTERS •Performance hydraulic roller lifters dyno developed and track tested •CNC-machined and precision ground •When used with Feuling® oil pump, they will increase critical oil flow to valves, springs, rockers, shafts and valve guides •Extend life of top-end valve gear •Can also be used for OEM replacements •Sold in a set of four •Made in the U.S.A. PART # DESCRIPTION 0929-0022 For 84-99 Evolution Big Twin RACE SERIES® FULL-TRAVEL HYDRAULIC LIFTERS •Full-travel hydraulic lifters made from machined steel designed with 0.200” of travel •Exceed the needs of large-lift camshafts and higher spring pressures with a slower bleed-down rate •Maintain proper and critical oil flow to valves, springs, rockers, shafts and valve guides •Increase engine rpm and valvetrain stability; decreases valve float for maximum valve lift •Recommended for both strip and performance street engines •Sold in a set of four •Made in the U.S.A. NOTE: High-volume oil pump recommended. NOTE: Recommended for engines running higher than 185 lbs. valve spring seat pressure. PART # DESCRIPTION FOR 53-84 BIG TWIN 0929-0051 Standard-hydraulic tappet assembly (4 pk.); repl. OEM #18522-53A 0929-0065 Std. hydraulic tappet assembly (ea.) 0929-0052 +0.003” hydraulic tappet assembly (4 pk.) HYDRAULIC TAPPET ASSEMBLIES •Precision-machined and heat-treated bodies •Premium-quality anti-pump-up hydraulic inserts •Eliminate noise from the mechanical valve train •Made in the U.S.A. 0929-0051
RkJQdWJsaXNoZXIy NDI5NTY=