BOLD MAGENTA part numbers are new for 2026 PARTSCANADA.COM 2026 | ATV/UTV PLOWS & IMPLEMENTS 60 DESCRIPTION PART # Seasonal bracket plow mount 4501-1338 DESCRIPTION PART # Swift-Latch™ mount 4501-1337 PLOW MOUNTS FOR CAN-AM DEFENDER HD11 SEASONAL BRACKET PLOW MOUNT •Two-piece design similar to other removable KFI mounts • When both brackets are installed, ground clearance is reduced by roughly 4” •The upper section can remain installed year-round •The seasonal bracket can be attached only during plow season and removed afterward for full clearance •Designed for stock-height machines - no leveling kit required • Lifted or modified machines (larger tires, tracks, etc.) will require a leveling kit to correct the plow angle SWIFT-LATCH™ MOUNT •Designed for year-round use with no loss of ground clearance •Includes a Swift-Latch™ Bar compatible with: PART #4501-1127, standard - for stock-height machines and PART #4501-1248, tall - for machines with tracks or oversized tires •Also features standard mounting tabs; if those are used instead of the KFI Swift-Latch Bar, a leveling kit is required 4501-1337 4501-1338 • 3 to 4” leveling kit for stock machines •Larger leveling kit for modified ride heights NOTE: Our KFI Glacier Adapters PART #4501-1127 and PART #4501-1248, have been renamed to Swift-Latch™ Systems. DESCRIPTION PART # Universal ATV plow mount 4501-1053 UNIVERSAL ATV PLOW MOUNT •Grade 50 steel construction •Shot-blasted before powdercoated •Works with most OEM skid plates •Works with the KFI Manual Lift Kit •3-piece universal adjustable design to fit most ATVs •Mounts to similar location as our model specific mounts •Use the same plow system from ATV to ATV •Works with KFI ATV standard push tube system PART #4501-1012 •Works with Cycle Country standard ATV mid-mount push tubes DESCRIPTION PART # Standard 2.0 glacier adapter w/ square tubes 4501-1127 DESCRIPTION PART # Tall 2.0 glacier adapter w/ square tubes 4501-1248 SWIFT-LATCH™ SYSTEMS •Designed for full-size Polaris Rangers with the Glacier bumper •Mid-size machines (unless modified) are too low to use the Swift-Latch™ system properly •Optimal height of the Glacier mounting location should be 14” from the ground NOTE: These were previously called 2.0 Glacier Adapters. NOTE: If this mount fits on your full-size machine but you have (or are going to install) tracks, larger tires, or a lift kit, we would recommend using the alternate mount PART #4501-1077 so that it will be compatible with our push tube leveling kits. 4501-1248 4501-1127
RkJQdWJsaXNoZXIy NDI5NTY=