WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES SECTION 7 All part numbers in BLUE are new for 2026. 567 See OLDBOOK For Early Model Applications DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 5-7 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. PART # DESCRIPTION 263507 Red, for 87-03 XL; repl. OEM #24650-87 PINION SHAFT BEARING •Direct replacement for the OEM bearing PART # DESCRIPTION 0924-0236 For all 00-02 Twin Cam “B” (right side) and all 03-07 Twin Cam (right and left side); repl. OEM #24604-00D PINION SHAFT BEARING •Sold each •Made in the U.S.A. PART # DESCRIPTION 0923-0381 For 07-16 Twin Cam (tapered wrist pin, 7.659” L) HEAVY-DUTY CONNECTING ROD SET •High-quality, heavy-duty rod set comes complete and ready-to-install •Set includes front and rear rods, crankpin and nuts, steel cages and roller bearings •Rods are deep-forged and heat-treated, 0.120” wider than stock in the I-beam section and feature rod-to-rod clearance to accommodate strokes up to and including 5” •Crankpin has two oil holes and rod has four slots ground on each side of the throw ends to help maintain the oil film on thrust faces •Made in the U.S.A. NOTE: Installation of rod sets may require additional clearancing of flywheels and cases. PART # DESCRIPTION 0921-0752 For 99-17 Big Twin and S&S “T” series engines PART # DESCRIPTION 0921-0164 For 86-99 XL CRANKPIN ASSEMBLIES •For use in stock and S&S flywheels •Made in the U.S.A. 0921-0164 PART # DESCRIPTION 0923-0354 For 05-17 Twin Cam (std.) WRIST PIN BUSHING •Constructed of SAE660 bearing bronze •Made to exact tolerances and will meet or exceed fitment and wearability of all other OE-style replacement bushings available •Sold each •Dimensions: 1.019” OD x 0.925” ID; overall length 1.040” •Made in the U.S.A. NOTE: Does not include oil holes. These must be drilled after installation. PART # DESCRIPTION 3801-0305 For 99-16 Twin Cam 0923-0379 For 99-16 Twin Cam w/ 5-piece flywheel, 99 Big Twin w/ V111, V117, V124 crank WRIST PIN BUSHINGS •Meet or exceeds fitment and wearability of OEM bushings •Sold each •Made in the U.S.A. 0923-0379
RkJQdWJsaXNoZXIy NDI5NTY=