WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES All part numbers in BLUE are new for 2026. SECTION 10 778 See OLDBOOK For Early Model Applications DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 5-7 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. PART # DESCRIPTION EMIS* DSK61 For 86-03 XL (except XL1200S); dual-fire ignition kit 1 IGNITION AND COIL KIT •Complete electronic ignition system built with the latest state-of-the-art engineering •The same ignition used by top drag and road racers to set records and bring home victories over the past decade •The Dyna S is completely housed behind the ignition cover and uses a magnetic rotor with the original advance unit, so the factory advance curve is maintained •Coils provide spark voltages in excess of 30,000V and spark energies second to none •The DSK61 Dyna S and coil system includes a DC7-1 high energy coil •Made in the U.S.A. NOTE: Not for fuel-injected models. NOTE: Later models will require the use of a mechanical advance unit. PART # DESCRIPTION EMIS* 2101-0242 For 86-97 XL (mode switch position 9 can be used to set kickstart, single-fire race advance curves w/o use of the USB interface) 1 PART # DESCRIPTION EMIS* 2101-0075 USB interface kit N/A INTERNAL IGNITION KIT •Includes ignition system, 8.5 mm spark plug wires, single-fire coil and instructions •Ignition system has two advance curve families with adjustable advance curves to accommodate stock to wild engine modifications •Four rotary switches for adjusting timing and single/dual fire rpm limit •Digitally set rpm limit (in 100 rpm steps), selectable single- or dual-fire mode •Selectable multi-spark mode for quick starting and smooth cruising •Coil outputs protected against short circuits •Optional USB interface kit and software available for programming custom curves (programs available on website www.daytona-twintec.com) •Requires the use of an OEM timing rotor (OEM #32402-83 or PART #2101-0234) •Uses the tachometer wire for the USB interface and comes with a connector •Made in the U.S.A. NOTE: Not for fuel-injected models. APPLICATION CHART FOR DYNA COILS WHEN USING DYNA “S” IGNITION SYSTEMS DESCRIPTION DESCRIPTION PART # W/ single-plug heads Street, 5-ohms (black), pair DC10-1 W/ dual-plug heads Street, 5-ohms (black), pair DC8-1 W/ single-plug heads Race only, 3-ohms (green), pair DC3-1 DESCRIPTION DESCRIPTION PART # W/ dual-plug heads Race only, 3-ohms (green), pair DC1-1 W/ dual-plug heads Race only, requires two coils, 3-ohms (green), each DC6-1 PART # DESCRIPTION EMIS* DS6-2 For 86-03 XL using a mechanical advance unit 1 SINGLE-FIRE ELECTRONIC IGNITION SYSTEM •All the features of the famous Dyna “S”, plus the special feature of firing the front and rear cylinders independent of each other, allowing a much more accurate timing of each cylinder •The stock ignition system fires both cylinders at the same time, which works fine for the front cylinder but the rear receives the “wasted” spark when the cylinder has started its intake stroke; this can result in harder starting, increased engine vibration, backfire and raw fuel being spit back into the carb, all creating a power loss •Dyno and top-speed testing have shown a dramatic improvement in power in all areas; bikes with hotter cams show the greatest improvement •If you truly want to get the most out of your stock, slightly modified or all-out customized Harley-Davidson, you need a Dyna “S” single-fire ignition system •Made in the U.S.A. NOTE: Not recommended for use with OEM coils. NOTE: An advance weight mechanism is required. NOTE: This unit must be used with special Dyna coils; see coil chart for correct coils. NOTE: Tach adapter is required when using an electric tach. NOTE: Not for use on Twin Cam. 2101-0075 2101-0242 DS6-2
RkJQdWJsaXNoZXIy NDI5NTY=