BOLD MAGENTA part numbers are new for 2026 PARTSCANADA.COM 2026 | OFFROAD BIKES, STANDS & ACCESSORIES 82 DESCRIPTION PART # Universal Finger-Grip™ cradle 0603-0477 RAM® UNIVERSAL FINGER-GRIP™ CRADLE •This mount is designed to hold cell phones (check measurements below for dimensions) and electronic devices •High-strength composite •Comes with three sets of four flexible rubber-coated fingers placed along the sides to grip your device •The fingers open by squeezing the ends of the holder •The bottom of the holder includes a back plate that adds support to the device being held by the mount •Can also be used with several other phone accessories •The spine plate contains the universal AMPS and 1.5” x 2” hole patterns •Height dimensions: minimum with top and bottom plates is 5.25” and maximum with top and bottom plates is 6.0” •The top and bottom plates can be removed for larger devices • Spine plate dimensions: 3”W x 3” H •Using short-arm side clamps: maximum depth is 0.75”, minimum width is 1.25” and maximum width is 3.0” •Using medium-arm side clamps: maximum depth is 1.25”, minimum width is 1.5” and maximum width is 3.5” •Using long-arm side clamps: maximum depth is 1.6”, minimum width is 2.25” and maximum width is 3.5” •Made in the U.S.A. NOTE: Does not come with ball mount adapter; use PART #0603-0472 to mount to RAM® double-socket arm. DESCRIPTION PART # RAM® Track Ball™ w/ T-bolt attachment 0603-0828 RAM® TRACK BALL™ WITH T-BOLT ATTACHMENT • B-size, 1” rubber ball molded to a high-strength composite base •Rubber friction washer and a stainless steel T-bolt for sliding into virtually any track system • Insert or slide the Track Ball™ into your track and twist the ball clockwise to tighten in place; twist counterclockwise to loosen DESCRIPTION PART # RAM® socket arm 0603-0942 RAM® SOCKET ARM •High-strength composite • Features a long, preassembled extension pole with 1” and 1.5” ball single open sockets • Socket ends swivel 360°, allowing you to rotate the camera adapter in any direction •Pole length (socket end to socket end) is 18” DESCRIPTION PART # Wireless charging holder w/ U-bolt handlebar mount and hardwire charger 0636-0175 RAM® TOUGH-CHARGE™ WATERPROOF WIRELESS CHARGING HOLDER • Powdercoated, marine-grade aluminum construction with stainless steel components and high-strength composite •Designed with spring-loaded X-Grip® technology; features an ‘X’ design that expands and contracts to secure nearly any phone while taking advantage of Qi wireless phone charging •Four arms feature rubber-coated caps that hold devices firmly in place • Includes a 1” B-size rubber ball with a diamond base, perfect for attaching any B-size RAM® double-socket arms • Connected Type-A male pigtail connector features an in-line switch that allows you to turn off the wireless charging module when not in use •Compatible with handheld devices that will fit the following dimensions: minimum width of 2.375” and maximum width of 3.25”, maximum depth of 0.875” •Includes a double-socket arm and mount •Safety device tether included that is recommended for outdoor applications
RkJQdWJsaXNoZXIy NDI5NTY=