BOLD MAGENTA part numbers are new for 2026 RIDER & SLED ACCESSORIES PARTSCANADA.COM SNOW | 2026 RIDER & SLED ACCESSORIES 151 DESCRIPTION PART # RAM® universal Finger-Grip™ cradle 0603-0477 RAM® UNIVERSAL FINGER-GRIP™ CRADLE •This mount is designed to hold cell phones (check measurements below for dimensions) and electronic devices •Made of up a high-strength composite •Comes with three sets of four flexible rubber-coated fingers placed along the sides to grip your device •The fingers open by squeezing the ends of the holder •The bottom of the holder includes a back plate that adds support to the device being held by the mount •Can also be used with several other phone accessories • The spine plate contains the universal AMPS and 1.5” x 2” hole patterns •Height dimensions: minimum with top and bottom plates is 5.25” and maximum with top and bottom plates is 6.0” •The top and bottom plates can be removed for larger devices • Spine plate dimensions: 3”W x 3” H •Using short-arm side clamps: maximum depth is 0.75”, minimum width is 1.25” and maximum width is 3.0” DESCRIPTION PART # Finger-Grip™ w/ EZ-Strap™ rail mount 0603-1026 FINGER-GRIP™ UNIVERSAL HOLDER WITH EZ-STRAP™ RAIL MOUNT •RAM® EZ-Strap™ base with double ball short arm, diamond adapter base and universal Finger-Grip™ cradle for cell phones and electronic devices • Strap can be cut to fit tubing, square rails and irregular shapes from 0.5” to 2.58” in diameter •Multiple adjustment points allow you to move the mount to your optimum viewing position •Mount rotates 180° •Cradle comes with three sets of four flexible rubber-coated fingers placed along sides to grip device •Fingers open by squeezing the ends of the holder •Bottom of the cradle includes a black plate that adds support to the device being held • Spine plate contains the universal AMPs and 1.5” x 2” hole patterns •Using medium-arm side clamps: maximum depth is 1.25”, minimum width is 1.5” and maximum width is 3.5” •Using long-arm side clamps: maximum depth is 1.6”, minimum width is 2.25” and maximum width is 3.5” •Made in the U.S.A. NOTE: Does not come with ball mount adapter; use PART #0603-0472 to mount to RAM® double-socket arm. DESCRIPTION PART # X-Grip® cradle 0603-0478 DESCRIPTION PART # X-Grip replacement tether 0603-1093 RAM® UNIVERSAL X-GRIP® CELL PHONE CRADLE WITH 1” BALL •High-strength composite and rustproof marine-grade stainless steel construction •Spring-loaded holder expands and contracts for perfect fit on your device •Rubber-coated tips will hold device firm and stable • Includes 1” ball; mount adapter is not required •Versatility of holder allows for attachment to many RAM® arms • Cradle Dimensions: 1.875” to 4.25” W, 3.25” to 2.25” H and 0.875” depth •X-Grip® includes a device tether •Made in the U.S.A. NOTE: It is important to verify the dimensions of your handheld device with a case/sleeve/skin when determining the overall size. 0603-0478
RkJQdWJsaXNoZXIy NDI5NTY=