BOLD MAGENTA part numbers are new for 2026 LIGHTING PARTSCANADA.COM STREET | 2026 LIGHTING 591 DESCRIPTION PART # Wiring harness extension Y cable 2120-1252 WIRING HARNESS EXTENSION Y CABLE •Designed to extend and split output line on Brite Lites HD wiring harnesses • Features two male and one female DT connectors on 4’ cable DESCRIPTION PART # Pulse™ type LED light bar wiring harness kit 2050-0486 PULSE™ TYPE LED LIGHT BAR WIRING HARNESS KIT •Specifically designed for use with the Pulse™ electrical input plug •Crafted with a thru roll bar design for simple and clean routing to the roof with little effort •Eliminates many steps during installation of any Pulse bar type electrical connector DESCRIPTION PART # Rocker switch adaptor kit 2050-0485 ROCKER SWITCH ADAPTER KIT •Optimized for snowmobiles with large factory knockout holes in the dash • Slips over rocket switch to fill a 1.70” x 0.830” open dash or pre-scored dash knockout hold •Comes in a 5-piece pack for best results during installation NOTE: Shown with LED lightbar switch, not included. DESCRIPTION PART # Universal 4-wire weathertight quick-disconnects 2130-0316 UNIVERSAL 4-WIRE WEATHERTIGHT QUICK-DISCONNECTS • Quick-disconnect for any two, three or four wire auxiliary lighting product •22 AWG wires • 15” total wire length •Four-pin JAE connectors •Sold in pairs DESCRIPTION PART # Diode kit 2050-0072 DIODE KIT •For metric cruisers with one turn signal indicator bulb •Kit is required when front turn signal bulbs are replaced with LEDs DESCRIPTION PART # Standard DOT flasher 2050-0070 STANDARD DOT FLASHER •Replaces stock 2- or 3-pin flashers on most metric bikes •Only one unit needed when replacing stock turn signals with LEDs on front and rear •Maximum 120W
RkJQdWJsaXNoZXIy NDI5NTY=