BOLD MAGENTA part numbers are new for 2026 EXHAUST PARTSCANADA.COM STREET | 2026 EXHAUST 69 DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 4-6 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. DESCRIPTION PART # 8” 2120-0144 DESCRIPTION PART # 14” 2120-0145 STAINLESS STEEL CABLE TIES •Perfect for high-temperature applications •Ball bearing and barb fastening assembly locks tightly and will not slip •Use anywhere a normal cable tie isn’t strong enough or can’t take the heat •Two lengths available; sold in packs of five •Made in the U.S.A. 2120-0145 DESCRIPTION PART # 62 mm 2404-1024 DESCRIPTION PART # 80 mm 2404-1025 EXHAUST PIPE SPRINGS •62 mm size are stainless steel with a double swivel design •80 mm size are zinc-plated steel •Sold in packs of 4 SIZE PART # 87 mm; black zinc plated steel 1860-2456 85 mm; stainless steel 1860-2455 EXHAUST PIPE SPRINGS FOR HONDA •Sold in 4-packs SPRING LENGTH PART # 38 mm M7713 57 mm M7714 60 mm M7715 SPRING LENGTH PART # 63 mm M7709 67 mm M7710 70 mm M7716 SPRING LENGTH PART # 75 mm M7711 80 mm M7717 83 mm M7712 SPRING LENGTH PART # 90 mm M7718 100 mm M7720 EXHAUST SPRINGS •Stainless steel construction gives superior strength and attractive appearance • Swivel hook design eliminates binding, extending spring life •Available for most late-model 2-stroke and 4-stroke models •Sold in pairs •Made in the U.S.A. DESCRIPTION PART # Exhaust rivet kit 1860-0176 EXHAUST RIVET KIT •Have the right parts ready to complete the job •Steel rivets with corrosion resistant coating • Rivets designed to be pulled by a hand operated rivet gun, no air power needed •Rivet diameter 3/16” with a grip range of 0.125” to 0.6” •Kit includes 20 rivets and 1 properly sized 3/16” drill bit •Made in the U.S.A. SIZE PART # 3” L DS-203060 SIZE PART # 4 3/4” L DS-203070 EXHAUST HANGER BRACKETS •Chromed 1/8” thick steel exhaust hangers •Sold each NOTE: When measuring for exhaust spring length, please use points #1 - #3 for reference. 1. Exhaust springs should be measured when they are off the vehicle.Wear eye protection when removing. 2.The length measurement should be taken from inside hook to opposite end inside of hook. 3. For correct fit, an exhaust spring should not be extended more than 20% of its free length. DS-203060 DS-203070 2404-1025 1860-2456
RkJQdWJsaXNoZXIy NDI5NTY=